got some work done today!

So today I cut the front section out of my bed and started welding it back together.  It took a little more adjusting than most guys make it seem like is needed.  I also ran into a lot of body filler.  I think its quite substantial. I am going to have to use a piece of the other side of the panel that I cut off today. either that or I straighten it as best as I can.  Thanks for looking. Let me know what you think.

 

 

 

I know its been a while!

So I finally had some time today to start working on the truck again. A few weeks ago I ordered some 5" drop springs for the back. So I decided to get started installing them today. I got the rear end in and some wheels on it. It looked nice so I decided to put the bed on it so that I could have more room to cut it down. So after putting the bed on by myself, I decided that it looked too good to stop working on it. So I got my welder all set up so for the sheet metal. Then I braced it up with some angle iron. I started to cut one cut but it was late so it will have to wait.  So what do you guys think of the ride height?